You are here: Home > 3M Communications > 3M Fiber Connectors, Adapters and Splices > 3M Fiber Connector Tools > 3M Epoxy Termination Tools
We found 0 results matching your criteria.
3M provides connectors with zirconia ceramic ferrules for use with two-part or anaerobic epoxy.
These very high quality connectors are ideal for use in factory assembly applications or in field-mount restorations where a broad temperature range and stringent performance standards are required. The following 3M materials are available to use with common termination tools available on the market.3M highly recommends 3M™ Epoxy 8692 which is cured at 87°C or higher for 20 minutes minimum to meet Telcordia GR-326 requirements. It is also important to use the proper syringe dispensing tip to assure proper placement of adhesives inside the connector ferrule and avoid overflow.3M Epoxy SC/APC and FC/APC Connectors require the angle polishing puck included in the APC conversion kits.
3M Carbide Fiber Scribe 3M Cleaning Wipes with Dispenser
3M Fiber scribe to remove the fiber stub form the connector end face.
3M Cleaning wipes with dispenser.
3M Cover Release Wipe 3M Dispensing Tips
3M Cover Release Wipe CRW100 100/CTN
3M Dispensing tips (green).
3M Epoxy For Fiber Optic Connectors 3M Lapping Film
3M Epoxy for 3M fiber optic connectors.
Use on extremely hard materials for repeatable, precision finish. Combines micron-graded diamond
3M Lint Free Cloth 3M Soft Polishing Pad
Consumable in Fibrlok, No Polish Connector, Hot Melt and Crimplok Field Termination Kits.
3M Soft polishing pad for ultra high temp 3M Hot Melt polish.
3M Syringe 3M View Scope 200X
3M Syringe, 3 cc. for injecting adhesive into the 3M connector.
3M View scope 200X with oblique and coaxial lighting for fiber end face viewing.